Basic Operation; Video And Photos; Recording Video - Velleman CAMCOLI5 Manual Del Usuario

7.1

Basic Operation

1. Press the power button [1] to switch on the camera and display.
Note: When the battery icon
2. Insert the camera head [3] into the space you want to inspect.
The gooseneck should easily manoeuvre into position. Do not apply force.
o
For the best images, hold the lens 2 ~ 5 cm from the object to inspect.
o
3. Turn the LED brightness wheel [6] to adjust the intensity of the LEDs on the camera head.
4. Press and hold the power button [1] for 3 seconds to switch the camera off.
7.2 Tools
Slide the plastic clamp of the tool [14] over the narrow part of the camera head [3] until it snaps into
place.
•
Attach the magnetic top to the camera to pick up small metal pieces from difficult to reach locations.
•
Attach the hook to retract wires or other small objects.
•
Use the small mirror to look behind corners.
7.3

Video and Photos

Recording Video

1. Make sure an SD card is installed in the camera.
2. Switch the camera on.
The display shows the remaining recording time in minutes and seconds (MM:SS) at the top left.
3. Insert the camera head into the space you want to inspect.
4. Press and hold REC [5] for about 3 seconds to start recording. "Rec." appears on the display.
The display shows the recording time in minutes and seconds (MM:SS) at the bottom right. You can
check the remaining recording time at the top left.
Note: The remaining recording time is an estimate. It depends not only on the time already
recorded, but also on the light conditions in which you have recorded.
5. Press and hold REC for about 3 seconds to stop recording. "Rec." disappears from the display.
Note: When the memory card is full, "MEMORY FULL" appears on the display and the camera stops
recording. You need to delete some files to make free space. If necessary, connect the camera to a pc to
back up the files before you delete them.
Play Back a Recorded Video File
1. Make sure recording is stopped.
2. Press ESC.
3. Use ▲ and ▼ to select the video icon
4. Use ▲ and ▼ to select the desired video and press SET.
5. Press SET to play the video. The display shows the playing time and the total recorded time of the
video.
Press SET once to pause, press again to resume playback.
o
Playback stops automatically at the end of the file. You can press ▼ at any time to stop playing
o
and return to the start of the video.
6. Press ESC to return to the list of videos.
7. Press ESC to exit.
V. 01 – 06/09/2012
CAMCOLI5
on the display turns red, you must charge the battery.
and press SET. The list of videos appears.
6 ©Velleman nv