Lega 4410EM Manual De Instrucciones página 15

3.2 MAINTENANCE
No special maintenance is required.
At the end of each work day, clean honey off the parts which have come in contact with the product during
work.
The machine should be washed with warm water and commercially available special mild detergents, if
necessary.
A pressure cleaner may also be used for a more thorough cleaning, paying attention not to direct the water jet
towards the control panel.
shown in the second picture) by using a 17 open-end wrench.
Pull out the mesh cylinder with the hopper.
Any residual honey in the hopper would make this operation easier by acting as
lubricant.
Before reassembling the unit by reversing the order of the listed operations, use some vaseline grease on the
screw feeder to facilitate smooth cylinder introduction.
LEGA
srl
Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
CAUTION! DISCONNECT POWER TO THE MACHINE!
Maintenance operations should be carried out after
stopping the machine and disconnecting all electric
circuits.
Extraordinary
particularly recommended at work
end: disassemble the mesh cylinder
as described below.
Remove
loosening the screws (as shown in
the picture) using a 4 Allen key.
Loosen the 4 hex head screws (as
CAUTION! Do not pull the cylindrical cage out, using
iron hammers, levers or other tools which may
damage the surface of the cage thus impairing
proper screw feeder-cage coupling.
maintenance
the motor cover
is
by
15 / 54