GB
3 Operating
3.2
Switching the
unit on and off
3.3
Operating time
14
1. Make sure that the MASSAGE switch
0 position, hold the massage device firmly and push the mains plug into a
properly installed mains socket intended for this purpose.
2. This device has two settings for massage intensity LOW (I) and HIGH (II).
Slide the MASSAGE switch
massage function. Slide the MASSAGE switch back to the 0 position to
switch the massage function off.
a. Use setting I and apply light pressure to relax and massage hard, tense
muscle areas.
b. Once tension has begun to dissipate, select setting II and gradually begin
to increase the pressure to stimulate deeper muscle tissue as well.
3. Slide the HEAT switch
HEAT switch back to the 0 position to switch the heat function off.
a. This device includes a special soft rubber massage surface
covers a third of the total surface of the heat area
4. Attachment a may be used to perform a spot massage, attachment b to per-
form a roller massage and attachment c to perform acupressure.
a. Always switch off the device and remove the plug from the mains before
changing a massage attachment.
b. Press the desired attachment firmly into position in the mounting on the
massage head opposite thesoft rubber massage area. Twist the massage
head inthe opposite direction as necessary.
5. a. The massage head
b. Press the RELEASE button
handle
. Adjust the angle by twisting both parts of the articulated joint
inwards with the RELEASE button pressed in. Release the button when
the desired position has been achieved and the joint will lock in place.
6. Turn the device off and unplug from the mains when not in use. Store in a
dry place out of the reach of children. Coil the mains cable loosely and secure
with a rubber band.
• You can give yourself or a partner a massage. Switch the unit on as described
above and apply to the part of body to be massaged. Simultaneous use of
the red light function improves the effectiveness of the massage. Do not con-
centrate on one side of the body for too long (max. 1 minute); rather change
the area of massage frequently.
• Choosing the direction of the massage you can decide on the effect: a mas-
sage toward the heart relaxes, a massage away from the heart stimulates.
• For a full body massage, please refer to Safety Information.
• Each session should not be more than 10 - 15 minutes. To ensure positive
results, please use the massager regularly.
• After treatment, switch the massage device off, pull out the mains plug and
let the device cool down.
and the HEAT switch
into the desired position to switch on the
to position I to turn on the heat function. Slide the
may be rotated through 270° by twisting gently.
in the handle joint to adjust the angle of the
are in the
which
.