Technical Description; Description Of The Device; Connecting The Inverter - Dometic GROUP WAECO PocketPower SI102 Instrucciones De Uso

PocketPower SI102
5

Technical description

The device has a compact design for portable use. The heat generated during operation
is dissipated by a fan inside the device.
5.1

Description of the device

No. in
fig. 1, page 2
1
2
3
4
5
6

Connecting the inverter

NOTICE!
A
 The cable between the battery and the inverter may not exceed a maximum
length of 2 m.
 Make sure the plug (fig. 1 4, page 2) is firmly connected to the vehicle sock-
et. If the connection is loose, the plug may heat up and cause the inverter to
malfunction.
 Do not operate any connected power consuming device while driving the ve-
hicle. Only operate device when vehicle is stationary.
NOTE
I
If you connect the device to the cigarette lighter, remember that the ignition must
be turned on to supply it with power.
➤
Fasten the inverter as follows (fig. 2, page 2):
– Screw the rail to the floor.
– Push the inverter onto the rail.
➤
Insert the plug into a 12 V cigarette lighter socket or into a 12 V vehicle socket.
The middle pin (fig. 1 3, page 2) of the plug must be connected to the positive (+)
wire and the two side brackets (fig. 1 2, page 2) of the plug must be connected to
the negative (-) wire.
Connecting the 230 V device
➤
Insert the European-plug version of the 230 V device into the 230 V output (fig. 1 4,
page 2).
EN
Description
Status LED blue
Negative contact
Positive contact
230 V output
USB charger connection
Technical description
13