Technical Description; Connecting The Inverter; Fastening The Inverter - Dometic GROUP WAECO PerfectPower PP152 Instrucciones De Montaje Y De Uso

PerfectPower
5

Technical description

The PerfectPower inverter can be operated wherever there is a 12 V DC
vehicle socket (for PP152, PP402, PP602) and a 24 V DC vehicle socket (for
PP154, PP404, PP604). The device is additionally cooled with a load and
temperature dependent fan.
The maximum constant output for the devices is as follows:
 For PP152 and PP154 inverters 150 W
 For PP402 and PP404 inverters 350 W
 For PP602 and PP604 inverters 550 W
Never connect devices that have a higher power requirement.
The inverter is equipped with protection against thermal and electrical over-
loading, as well as excess and insufficient voltage. The inverter switches off:
 If its internal temperature is too high
 If the load exceed the values stated above
 If the input voltage is too high or too low
The inverter can be switched on and off using the switch directly on the
device or using an external switch.
NOTE
I
Note when connecting devices with an electrical drive (such as
power drills and refrigerators), that they often need more power
than is stated on the type plate.
6

Connecting the inverter

NOTICE!
A
The cable between the battery and the inverter may not exceed a
maximum length of 2 m.
6.1

Fastening the inverter

You can fasten the inverter using the four holders supplied.
When selecting the installation location, observe the following instructions:
 The inverter can be mounted horizontally or vertically.
 The inverter must be installed in a place that is protected from moisture.
EN
All manuals and user guides at all-guides.com
Technical description
21