Output Shaft; Maintenance And Cleaning; Technical Data - IKA RW 16 basic Instrucciones De Manejo

Output shaft

The clamping chuck and output shaft permit all standard
commercial stirrer tools up to 10mm diameter to be gripped and
screwed in. The opening on the top side of the housing is closed
with a slotted rubber diaphragm. It is, however, possible for stir-
ring shafts to push out over the top edge of the housing eg during
change of container.
If it becomes necessary - depending on the layout of the equip-
ment - to allow the shaft end to project over the edge of the hou-
sing during operations, the rubber diaphragm should be removed.
Instead a stirrer shaft cover, which can be obtained as an acc -
essory, must be placed on the housing. If the stirrer shaft cover
is removed again, the rubber diaphragm must be pressed into the
housing opening again so that this is closed. This is the only way
of ensuring safe working and preventing any fluids from penetra-
ting the equipment.
Please see section "Safety Instructions"!

Maintenance and cleaning

The stirrer is maintenance-free. It is subject only to the natural
wear and tear of components and their statistical failure rate.
When ordering spare parts, please give the manufacturing
number shown on the type plate, the machine type and the
name of the spare part.
Please send in equipment for repair only after it has been clea-
ned and is free from any materials which may constitute a
health hazard. Only use water with a detergent additive contai-
ning a surfactant for cleaning, or for heavier soiling isopropylal-
cohol.
RW160995EU
Accessories
R 1822 Fixed plate RH 1 Tension-holder
R 181 FK 1
Cross-sleeve
DZM 1 Speedometer; RLS 8 x 33

Technical data

Speed range under nominal load: min
-1
Max. stirrer speed: Ncm
Permitted switched-on time: %
Speed setting: Speed adjuster with pulse width modulator
Speed indicator: Scale on knob
Nominal voltage: VAC
VAC
Hz
Frequency:
Input power: W
Output power: W
W
Output on stirrer shaft:
Total efficiency:
Protection type to DIN 40 050:
Protection measures: 0
Class Protection device Recommended use
0 No additional protection Used only on equipment where
failure of the controls does
not represent a hazard.
The operating conditions should be monitored at regular intervals.
Excess voltage category:
Degree of pollution:
Overload protection: El. current limitation
Fuses (on mains plate): A 4 T (IKA ident.no. 25 851 00)
Flexible connection
40-1200
40
100
230 EURO
±10%
115 USA
±10%
50 / 60
75
55
53
0,71
IP42
II
2
13