Get Started; Install The Batteries; Recharge The Batteries; Recharge The Batteries Using The Philips Power Supply - Philips LFH 0955 Manual Del Usuario

2

Get started

2.1

Install the batteries

The Digital Pocket Memo can be operated with
the two rechargeable AAA batteries delivered
with the product. Standard (non-rechargeable)
AAA alkaline batteries may also be used.
The on/off switch of the Digital Pocket
1
Memo must be in the
Open the battery compartment on the back
2
side of the Digital Pocket Memo by sliding it
outwards then folding it up.
Insert the two AAA batteries. The correct
3
polarity is indicated on the inside of the
battery compartment cover.
1
Close the battery compartment by folding
4
it back and sliding the battery compartment
cover inside until it clicks.
D Note
Do not mix battery types! Use two rechargeable
batteries or two non-rechargeable alkaline
batteries.
User manual
position.
OFF
1 2
2
2.2

Recharge the batteries

The Digital Pocket Memo can be operated
with the rechargeable Philips AAA batteries. To
recharge these batteries, use the
supply, the Docking Station
2.2.1 Recharge the batteries using the
Philips power supply
Connect the Philips power supply to the
1
main power supply.
Connect the Digital Pocket Memo to the
2
Philips power supply.
D Note
It is okay to continue using the Digital Pocket
Memo during recharge. The batteries will be
recharged while you work, and will continue
recharging even when the Digital Pocket Memo
is turned off.
2.2.2 Recharge the batteries through the
USB cable
When the Digital Pocket Memo is connected to
a PC or notebook computer with the supplied
USB cable, the rechargeable batteries are
automatically recharged. If the USB port on the
computer is high powered, a complete recharge
cycle takes about 2.5 hours.
The Digital Pocket Memo switches into
Download mode and works like a loudspeaker
and microphone for the connected PC. To
continue recording on the Digital Pocket Memo
Philips power
or the USB cable.
PC
7