Parts Subject To Wear And Tear - Solo 69 00 227 Manual De Instrucciones

Preface
Dear Customer,
Congratulations for choosing this SOLO
quality product.
The brushcutter attachment 69 00 227 is
delivered without a shaft tube. It is designed for
the SOLO brushcutter with loop handle
described in chapter 6.2 "Installation", with
25cm 3 and 29 cm 3 engine, 24mm shaft tube
diameter and with rigid shaft drive (7 toothed
star gear).
The brushcutter attachment 69 00 228 is
delivered with a lower shaft tube. It is solely
designed for installation on the SOLO
brushcutter 129LTS with sectional shaft. A
simple, quick tool change is made possible as the
lower shaft tube can be replaced with the tool
head attached.
These instructions will only highlight the
additional aspects of the base tool and the
installed hedge trimmer as opposed to the
instructions detailing the use of the brushcutter.
Basically, all the instructions for the brushcutter
are to be taken into account, in particular the
safety instructions.
We wish you many years of problem free,
successful work.
If, after having read both these instructions
and those of the brushcutter you still have
questions, then please contact your local SOLO
dealer or our service department directly.
CE Declaration of conformity
SOLO Kleinmotoren GmbH, Stuttgarter Str. 41,
D-71069 Sindelfingen,
hereby declares that the following machine, to which
this declaration refers, meets the requirements of the
EC Directives 98/37/EC, 2000/14/EC and 89/336/EEC (as
amended by 92/31/EEC)
Product designation:
Model/type:
meets the requirements of the Machinery Directive.
This declaration of conformity loses its validity, if the
equipment is converted or modified without the
manufacturer's consent.
Sindelfingen,
1 January 2005
st
SOLO Kleinmotoren GmbH
ENGLISH 2
Hedge trimmer attachment
69 00 227 / 69 00 228
Wolfgang Emmerich
Executive Director
Symbols
The following symbols are used in these
instructions and on the tool which are additional
to the symbols used on the brushcutter:
Read these instructions and the
brushcutter instructions
Always handle this tool with particular
care
Wear a protective face shield
Never touch the cutting blades

1. Parts subject to wear and tear

Various parts are subject to application-specific
or normal wear and must be replaced in good
time, when required. The following parts are
subject to normal wear and are not covered by
the manufacturer's guarantee:
Cutting blades
Lubricants