Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Risk of injury from breaking glass!
Don't prick or hit the glass panel with pointed or
Z
X
sharp objects and don't bump the glass edges.
Hazards
The device contains electrical components.
The scale is dust-proof and slash-proof (IP65).
However, the device only meets this safety class if
all the specified protective measures are applied.
If protective caps are not used (e.g. in the sockets)
or seals are broken (e.g. on the feet), the device
protection is no longer guaranteed.
Make sure that electrical parts (connectors,
Z
X
cables) do not come into contact with water.
Make sure that no liquid enters the interior of the
Z
X
device.
Risk of fire and electric shock!
Ensure that the values for mains voltage and
Z
X
current indicated on the nameplate of the power
pack match those of the socket.
Use only accessories (connectors, cables)
Z
X
approved by the manufacturer and the power
supply unit provided.
In case of damaged seals or unused protective
Z
X
caps: Do not use the device in wet areas or in the
sink!
Fire and explosion hazard!
If the lid of the battery compartment is bulging:
Z
X
Stop using the device.
Take the scale outside immediately.
Z
X
Extinguish burning batteries with sand or an ABC
Z
X
extinguisher.
Only transport in fire save case.
Z
X
Have the scale repaired.
Z
X
Risk of burns!
Do not touch smoking or burning batteries with
Z
X
bare hands, as they can become very hot and can
cause burns.
FS GLT
The device contains batteries.
Charge the batteries of the device at room
Z
X
temperature.
Never expose the device to a temperature below
Z
X
0°C (32°F) or above 45°C (113°F).
Only allow batteries to be exchanged or repaired
Z
X
by a specialist.
Do not open the device. Do not remove, exchange
Z
X
or repair batteries yourself.
Do not plug in the charging cable in wet areas or
Z
X
in the sink.
Cleaning
The device contains electrical components.
Do not immerse the device in water or other
Z
X
liquids.
Do not use pressurised steam, steam cleaners or
Z
X
direct jets of water to clean the device.
Do not use coarse abrasive materials or sharp
Z
X
metal scrapers to clean the glass parts of the
appliance. They could scratch the surface and
cause the glass to shatter.
Never use scouring pads, steel wool, muriatic acid
Z
X
or other products which could scratch or mark
the surface.
– 4 –
Publicidad
Tabla de contenido
