Cleaning And Care - Franke FS GLT Manual Del Usuario

Shifting units
The units g and OZ are available.
To shift the unit, press
X X
The unit shown in display changes.
„ „
Turning off the display / scale
Short press .
X X
The display turns off.
„ „

CLEANING AND CARE

Before performing any cleaning and care:
Read the general safety information about
Z X
cleaning in the chapter „Safety information".
Turn the appliance off.
X X
Disconnect the charging cable from the device
X X
and check the tightness of the protective cap.
Only clean the device with a damp cloth and
X X
commercially available detergent.
MAINTENANCE, REPAIR, DISPOSAL
Make sure that maintenance on electrical
Z X
components is carried out only by the
manufacturer or the customer service.
Make sure that damaged cables are changed only
Z X
by the manufacturer or the customer service.
Contact a service centre authorised by the
Z X
manufacturer or qualified personnel in the
following cases:
– Immediately after unpacking, in the event of
doubts regarding the integrity of the device
– Doubts regarding the correct operation of the
device
– Malfunction or poor operation
Use original spare parts only.
Z X
When contacting the customer service, please
X X
provide the following information: type of fault,
appliance model (Art.), serial number (S.N.)
This information is given on the data plate.
FS GLT
for 3 seconds.
– 7 –
Alarming
Display
Description
message
-OL-
Overload 9d (≥10d)
ERR A
Unusual weighing
ERR V
Low battery: The display turns off
after 2 seconds.
A
(only for service needs): The
display turns off after 2 seconds.
Packaging
All packaging materials (cardboard, plastic film (PE)
and polystyrene (EPS)) are marked and should, if
possible, be collected for recycling and disposed of
in an environmentally friendly way.
Disposal
The symbol on the product or on the
packaging indicates that the device must
not be disposed of in the domestic waste.
EN