Troubleshooting; Disposal - Silvercrest SLR 55 A1 Manual De Instrucciones

Maintenance and cleaning / Troubleshooting / Disposal
F irst, remove the HEPA / activated carbon pre-fil-
ter and then the activated carbon filter
6
(see Fig. CII and CIII).
I nsert a new activated carbon filter
product first, then insert the HEPA / activated
carbon pre-filter
6
HEPA / activated carbon pre-filter
facing forward.

Troubleshooting

Problem
The ON / OFF button
not responding.
The product is unusually loud
during operation.

Disposal

The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning: 1–7: plastics /
20–22: paper and fibreboard / 80–98: composite
materials.
34 GB/MT
in the
7
. The black side of the
must be
6
Possible cause
is The product is not connected to
12
the power circuit.
The fuse is at the 0 setting or is
defective.
Power failure
The front cover
assembled correctly.
The product is standing at an an-
gle or is on an uneven surface.
A filter ,
6 7
The air inlet and air outlet
are covered or blocked.
C lose the front cover
CIV.
7
H old the filter button
3 seconds until the beep sounds and the LED
on the button goes out.
Note: Replacement filters can be ordered online at
www.shop.targa.de.
Solution
Insert the mains plug
mains socket.
Set the fuse in your fuse box to the I
setting or replace the fuse.
Wait until the power has been
switched on again.
has not been Remove the front cover
5
it as depicted in Figure CIV.
Place the product on a stable, even
surface.
is clogged. Clean the HEPA / activated carbon
pre-filter
vated carbon filter
proceed as described in the chapter
"Maintenance and cleaning".
, Ensure that the air inlet and air outlet
8 3
8
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
This label indicates that this product may
not be disposed of in the domestic waste
throughout the entire EU. To prevent po-
tential environmental damage or damage to human
health due to unregulated waste disposal, please
as depicted in Figure
5
pressed for approx.
13
into the
4
5
and replace the acti-
6
. To do so,
7
, are not covered or blocked.
3
and close