TFA Dostmann 35.1064.01.51.IT Manual De Instrucciones página 83

POSITIONING THE TEMPERATURE TRANSMITTER:
The transmitter is supplied with a holder that may be attached to a
wall with the two screws supplied. The transmitter can also be
position on a flat surface by securing the stand to the bottom to the
transmitter.
To wall mount:
1. Secure the bracket onto a desired wall using the screws and
plastic anchors.
2. Clip the remote temperature sensor onto the bracket.
Note:
Before permanently fixing the transmitter wall base, place all units
in the desired locations to check that the outdoor temperature
reading is receivable. In event that the signal is not received,
relocate the transmitters or move them slightly as this may help the
signal reception.
82