Ega Master 56890 Manual De Instrucciones página 38

Failure to comply with the following cautions and warnings could cause equipment damage,
property damage or personal injury.
DANGER is only used when your action or lack of action may cause serious injury or even
death.
WARNING indicates a potential danger that requires correct procedures or practices to avoid
per-sonal injury.
CAUTION is used to indicate correct operating or maintenance procedures and practices to
prevent damage to, or destruction of equipment, or other property.
WARNING: Wear proper personal protective gear when operating hydraulic equipment.
DANGER: To avoid personal injury, keep hands and feet away from work-piece during
operation.
WARNING: Do not exceed equipment ratings. Overloading causes equipment failure and
possible personal injury. The pump tools are designed for a maximum pressure of 10,000
PSI (700kg/cm2). Do not connect a jack or cylinder to a pump. Never set the relief valve to a
higher pressure than the maximum rated pressure of the pump. Higher settings may result in
equipment damage and/or per-sonal injury.
WARNING: The system operating pressure must not exceed the pressure rating of the lowest
rated component in the system. Install pressure gauges in the system to monitor operating
pressure.
CAUTION: Avoid damaging hydraulic hose. Avoid sharp bends and kinks when routing
hydraulic hoses. Using a bent or kinked hose will cause severe back-pressure. Sharp bends
and kinks will inter-nally damage the hose, leading to premature hose failure. Do not drop heavy
objects on hose. A sharp impact may cause internal damage to hose wire strands. Applying
pressure to a damaged hose may cause it to rupture.
IMPORTANT: Do not lift hydraulic equipment by the hose or swivel couplers. Use the
carrying handle or other means of safe transport.
CAUTION: Keep hydraulic equipment away from flames and heat. Excessive heat will soften
seals, resulting in fluid leaks. Heat also weakens hose materials. For optimum performance do
not expose equipment to temperatures of 65° C (170° F) or higher. Protect hoses and cylinders
from weld spatter.
38
SAFE AND CORRECT USE