Pre-Setting A Long Distance Phone Carrier (Csp) - Intelbras ITC 4000 Manual Del Usuario

HAB:
0: disables function.
1: enables function.
Inserting a pre-number in the memory
This function is used to create a list of numbers, that once dialed will add
the prefix to the sequence of dialed numbers. This function depends on the
function Enabling a pre-number.
On the setting mode, press: 0 + 4 + 2 + 3 + * + pre-number + #.
Where:
Pre-number: list of each numbers, between 0 and 9, that will be analyzed
when their first digit is dialed.
Adding a prefix
This function is used to define which prefix will be added to the sequence of
dialed numbers. This function depends on the function Enabling a prefix.
On the setting mode, press: 0 + 4 + 2 + 2 + * + prefix + #.
Where:
Prefix: number that will be added at the beginning of the sequence of dialed
numbers.
Example: it is desired that to every call dialed, that initiates with a 2, 3, or 8,
may be added a 048 prefix. Thus, the following setting must be done:
Enabling prefix: ***99*222222#0421*1#.
***99*222222#0423*238#. If the dialed number initiates with 2, 3, or 8, the
preset prefix will be added.
***99*222222#0422*048#. Added prefix: 048. While dialing the number
32819500, the called number will be 04832819500.

Pre-setting a long distance phone carrier (CSP)

This function is used to select a long distance carrier company.
The ITC 4000 will analyze the dial number, and in case the dialed call, or
the Call back is to a long distance number, the long distance carrier preset
code will be added to it.
Note: in order to use this function, the carrier code must not be dialed.
Enabling the function
On the setting mode, press: 1 + 8 + 3 + 3 + * + HAB + #.
87