Special Functions - babymoov Babyphone Slim Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

B / Receiver

1. Place the receiver at a reasonable distance from the transmitter to avoid any interference.

2. When a signal is received from the transmitter, the receiver screen back light will be lit. The number of

LEDs (16) lit increases according to how loud the baby's voice is.

3. The loudspeaker volume can be set using the selection button (12). The more bars you display, the

higher the loudspeaker volume.

4. When the out-of-range alarm function is set to On on both the transmitter and the receiver, and if the

latter goes outside the transmitter communication range for more than 2 minutes, the out-of-range alarm

will be set off. The LEDs (16) will start to blink at the same time as the out-of-range symbol

temperature reading will show -- °C. The alarm and symbol will disappear once the receiver is once

again in communication range with the transmitter.

N.B. This alarm will also go off if the transmitter is stopped, if its battery level drops or the power

supply is cut, and if the channel/digital code/out-of-range settings on the receiver and transmitter are

not the same.

5. Each time the temperature in baby's room is outside the range defined by the maximum and minimum

limits set, the receiver will set off an alarm: the corresponding symbol (U or L) will appear and the current

temperature reading will blink on the screen.

6. By pressing briefly on the receiver mode button (13) the various settings will be displayed according to

a cycle:

The minimum temperature

limit is set at 16 °C

The maximum temperature

limit is set at 29 °C

7. The receiver can be worn

around the neck with a strap.

C / Transmitter and receiver

1. The transmitter and receiver battery condition is shown by the battery level indicator . When all the

power in the battery has been used up, the segments in the indicator gradually drop: once the indicator

is completely empty it starts to blink and an alarm is set off (in the receiver only).

2. For the transmitter, when only one segment is left in the battery level indicator , it will send a signal to

the receiver. The low battery symbol

Once the battery charge level indicator in the baby's unit , is completely empty, two beeps will sound.

3. Whenever a button is pressed, a beep will sound to confirm that your input has been recognised by the

unit. The sound level of the beep and the alarm is fixed and independent of the loudspeaker volume setting.

Night light

- Permanent setting: put the On button (1) at the

the screen.

- VOX mode setting (voice activation): press the microphone button (4), briefly, and the VOX symbol will appear

next to the

symbol. The night light will turn on when the microphone (7) detects a sound, and will turn

off automatically after a few seconds. Press the microphone button (4), again briefly, and the night light

will no longer be in VOX mode.

will start to blink on the receiver screen and a beep will sound.