In Case Of Problems - babymoov Babyphone Slim Manual De Instrucciones

Problem
• No transmission from the transmitter
• Transmits without interruption
• Out-of-range alarm activated without
interruption
• The out-of-range alarm is activated
sometimes
• The out-of-range alarm is never activated
• The temperature alarm is activated
without interruption
• The battery low warning is displayed
without interruption
• The battery life is short
• A lot of static and interference
• Communication range too short
20

IN CASE OF PROBLEMS

Possible causes
• The microphone sensitivity is set too low.
• The batteries have run out or the AC
adapter is not properly connected.
• The microphone sensitivity is set too high.
• The channel or digital code setting is not
the same on the transmitter and the
receiver
• The transmitter batteries have run out
• The out-of-range alarm setting on the
transmitter is on Off but the setting on the
receiver is on On
• The distance between the transmitter
and the receiver is greater than the
operating range.
• Interferences with other appliances
operating on the same channel.
• The out-of-range setting on the
transmitter and the receiver is on oFF.
• The out-of-range alarm setting in the
transmitter is on On but the setting in the
receiver is on oFF.
• The maximum
temperature limits are too close to the
current reading.
• The battery has run out.
• No battery inside the receiver.
• The battery is damaged.
• The night light is on permanently
• The vibration alarm is on.
• The transmitter is located close to other
electrical apparatus.
• The channel or digital code is the same
as your neighbour's.
• A large number of steel structures
between the transmitter and the receiver.
• The power output on the transmitter is set
to EL.
• The transmitter batteries have run out.
BABYPHONE SLIM • Instruction manual
• Increase the microphone sensitivity using
the selection button (2) and the
microphone button (4).
• Install new batteries or check the
connection.
• Decrease the microphone sensitivity
using the selection button (2) and the
microphone button (4) dso that the
transmitter is activated by voice (VOX
mode).
• Set the same channel and same digital
code on the transmitter and the receiver
• Replace them with new batteries or use
the AC adapter
• Change the setting of the out-of-range
alarm on the transmitter to On
• Bring the transmitter and the receiver
closer to each other.
• Change to another channel.
• Change both settings to On.
• Change the setting on the receiver to
On.
and minimum • Adjust the maximum and minimum
temperature limits to obtain a difference
of 5 °C relative to the current reading.
• Recharge the battery using the (receiver)
charger base. Replace with new batteries
or use the AC adapter for the transmitter.
• Replace the battery in the battery
compartment.
• Replace with a new battery.
• Turn off the night light or set to VOX
function.
• Turn of the vibration alarm.
• Remove the electrical appliances or move
the transmitter away from the source of
interference or change the channel.
• Change the channel or the digital code
on the transmitter and the receiver.
• Reposition the transmitter and the
receiver.
• Change the power output setting to Hi.
• Replace the batteries or use the AC
adapter.
Solution