Conditions Of Use; Assembly Instructions - INDUSTRIAS TECHNOFLEX Pentium Manual De Instrucciones/Lista De Recambios

1B
OPERATION
1.6

Conditions of Use

The vibro-surfacing Screed "PENTIUM" model, is designed to give maximum satisfaction to the user,
as long as the instructions of use and maintenance contained in this manual.
The "PENTIUM" Screed is, due to its original design, the ideal machine to attain a high quality finish
to concrete surfaces.
The "PENTIUM" Screed is designed to vibrate and surface concrete and be used under the hardest
conditions of work, both environmental as well as of use.
1.7

Assembly Instructions

The Vibro-Surfacing Screed "PENTIUM" comes pre-assembled except not with the vibrating or
surfacing screed.
To assemble these please follow the following instructions: (See fig.: 1.7-1)
A) Remove the two screws Pos. 1 from the strip of the machine.
B) Assemble the vibrating or surfacing strip Pos. 4 as shown in the diagram, placing a washer Pos.
2 on each side of the aluminium support.
C) Set up nut to Pos. 3 and tighten STRONGLY with a spanner, if not it may crack and the
aluminium borer strip may be damaged.
D) To disassemble the strips, follow the instructions in reverse.
1B-4
Fig.: 1.7-1
INGLÉS