Maintenance Table; Problem Identification - Stiga 100 Combi 3 EL QF Manual De Uso

13. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
General cleaning and inspection
Check the condition of the cutting-means
Check the condition of the transmission belt
Wheel shaft lubrication

14. PROBLEM IDENTIFICATION

PROBLEM
1. Unusual vibrations
while working
2. Uneven cut
3. The cutting means do
not engage or do not
stop promptly when
they are disengaged
If problems persist after having performed the above operations, contact your dealer.
PROBABLE CAUSE
Loose parts or damaged
cutting means.
Cutting-means assembly is full of grass Clean the cutting-means assembly
Inefficient cutting-means
Forward speed too high
compared to height of grass
Problems with the clutch system or
cutting-means transmission belt
Frequency
First time And then after every
-
-
-
-
5 hours
-
Tighten all fastening devices. Have
the damaged parts replaced c/o
an authorised service centre.
Contact your dealer
Reduce the forward speed and/or
raise the cutting height (par. 5.1)
Wait for the grass to dry
Contact the authorised service centre.
EN - 10
Before each use
Before each use
After each use
Before each use
25 hours
50 hours
SOLUTION
Paragraph
7.3
6.2
7.4
8.1
8.2
7.5