Connecting A Vcr; Connecling An S-Vhs Vcr - Samsung LN-S2651D Manual De Instrucciones

Connecting a VCR
These instmctions assume Thatyou have already connected your TV to an amenna or a cable TV system (according to The instructions on
pages 7-8). Skip step 1 if you have not yet conneclcd to an anlcnna or a cable system.
TV Rear Panel
Follow the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.
Each external input source device has a different back panel configuration.
When connecting an external device, match the color d the connection terminal to the cable.
For 40 inch model, use the cables with the ferdte core.
1. Unplug the cable or antenna
from the back of the TV.
2, Connect the cable or antenna
to the ANT IN terminal on the
back of the VCR.
3. Connect an RF Cable
between the ANT OUT
terminal on the VCR and the
ANT 1 IN (AIR) orANT 2 IN
(CABLE) terminal on the TV.
4, Connect a Video Cable
between the VIDEO OUT jack
on the VCR and the AV IN t
[VIDEO] jack on the TV.
5, ConnectAudio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN 1 [R-AUDIO-L] jacks
on the TV.
:_ If you have a "mono"
(non-stereo) VCR, use a
Y-connector(not supplied)to
hook up to the dght and left
audio input jacks of the TV.
If your VCR is stereo,you
must connecttwo cables,
Connecting an S-VHS VCR
Ynur Samsung TV can be connected to an S-Video signal from an S-VHS VCR.
this connection delivers a better picture as compared to a standard VHS VCR.)
TV Rear Panel
/;I-i RF Cable (Not supplied)
An S-Video cable is usually included with an S-VHS VCR. (If not, check your local electronics store,)
:_ Each external input source device has a different back panel configuration,
:_ When connecting an external device, match the color d the connection terminal to the cable.
:_ For 40 inch model, use the cables with the ferdte core,
1. To begin, follow steps 1-3
in the previous section to
connect the antenna or
cable to your VCR and
your TV.
2, Connect an S-Video Cable
between the S-VIDEO OUT
jack on the VCR and the
AV IN1 [S-VIDEO] jack on
the TV.
3, ConnectAudio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN1 [R-AUDIO-L] jacks
on the TV.
English-9