Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PSTx
12.30 Fieldbus AI 9
12.31 Fieldbus AI 10
19.04 Fieldbus failure op.
4.2 Danfoss - Vacon
FC 200
4–10 Motor speed direction
8-01 Control site
8-02 Control source
8-30 Protocol
8-31 Address
8-32 Baud rate
8-33 Parity / Stop bits
8-43 PCD Read
• [02] Configuration
• [03] Configuration
• [04] Configuration
• [05] Configuration
• [06] Configuration
• [07] Configuration
• [08] Configuration
MCD 200 – Con expansión RS 485 opcional.
Añadir un puente de cable entre los terminales A1–N2.
MCD 500 – Con expansión RS 485 opcional.
Añadir puentes de cable entre los terminales 17–18 y 18–25. Utilizar 19.200 baudios como máximo.
MCD 200, MCD 500
Protocol
Slave ID
Baud rate
Parity
Soft starter
Power factor
Not used
Consider change to "Stop-automatic" for avoiding manual trip
reset in case of intermittent corrupted Modbus messages
Variable speed drive
[2] Both directions
[2] Ctrl. word only
[1] FC port
[2] Modbus RTU
Unique slave ID corresponding to EC 531 setting
Same as EC 531
Same as EC 531
[1612] Motor voltage
[1613] Frequency
[1616] Torque [Nm]
[1617] Speed [RPM]
[1622] Torque %
[1610] Power [kW]
[1614] Motor current
Soft starter
Modbus RTU
Unique slave ID corresponding to EC 531 setting
Same as EC 531. Max 19200 baud.
Same as EC 531
13
ES
Publicidad
Tabla de contenido
