Exo Terra PT2445 Manual De Instrucciones página 4

DANGER
product.
care should be taken since water is/ may be employed in the
use of this product. For each of the following situations, do not
attempt repairs yourself; return the product to an authorized
service facility for service if it is still under warranty or discard
the product. Do not operate the appliance if it has a damaged
electrical cord or plug, or if it is malfunctioning or if it is dropped
or damaged in any manner. The power supply cord for this unit is
detachable and can be replaced if damaged. Replace supply cord
only with original Exo Terra
2. To avoid injury, do not contact moving or hot parts.
CAUTION -
3.
the outlet before putting on or taking off parts and while the
equipment is being installed, maintained or handled. Never yank
the cord to pull the plug from outlet. Grasp the plug and pull to
disconnect. Always unplug an appliance from an outlet when not
in use. Never lift this product by the cord.
4. This appliance is not intended for use by persons (including
children) with reduced physical sensory or mental capabilities,
or lack of experience or knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
5. The use of attachments not recommended or sold by the
appliance manufacturer may cause an unsafe condition.
6. Do not install or store the appliance where it will be exposed to
temperatures below freezing. Do not expose the unit to direct sunlight.
7. Ensure that the appliance is placed on a flat, even surface.
Monitor the product regularly. Do not leave the product
4
unattended for extended periods.
8. If an extension cord is necessary, ensure the connection is
watertight and dust proof. A cord with a proper rating should be
used. A cord rated for less amperes or watts than the appliance
rating may overheat. Care should be taken to arrange the cord so
that it will not be tripped over or pulled. The connection should
be carried out by a qualified electrical installer.
9. Indoor Household Use Only. Not for commercial use.
10. Do Not attempt to open rear of appliance. No User serviceable parts
inside. Refer all repairs to a qualified electrician or HVAC specialist.
SAVE THESE INSTRUCTIONS.
Initial Set-up and operation
This will need to be performed BEFORE placing eggs in the
incubator!
1. Place the Incubator on a flat, even surface.
2. Make sure that the Incubator does not receive direct sunlight
(overheating) or drafts (undercooling). Ideal operating
environment is an ambient room temperature of 18°-22°C (65°-
72°F).
3. Check if the AC/DC switch on the back of the device is set on
AC, then connect the plug to the wall receptacle. Push the on/off
button located on the front panel of the Incubator to switch on
the device.
4. Interior Light: if desired press the light switch on the front control
panel to turn the interior light on or off.
5. Set the preferred incubation temperature, ranging from 15° to
40°C (59° to 104°F) depending on the species, using the 'up
- To avoid possible electrical shock, special
replacement part.
®
Always unplug or disconnect the appliance from