Snapper 1226 Manual De Operación página 12

AssembJy
CONNECT SPOUT ROTATOR BRAKE
CABLE
1. Slide spout rotator brake cable (A, Figure 11)
between dash and the handle cross bar as shown.
2. Slide rubber dust cover (B) off of plastic fitting as
shown.
3. Place "Z" bend of cable (C) into hole of brake lever
assembly (D).
4. Pull plastic fitting (A, Figue 12) behind bracket (B).
5. Slide chute rotator cable (A, Figure 13) between slot
in bracket and push forward to lock in place.
6. Slide rubber dust cover (B) over plastic fitting.
REMOVE SNOWTHROWER FROM
CRATE
1. Cut straps from between snowthrower and wood pal-
let by wheels and auger.
Spout Rotator Brake Cable Figure 11
2. Roll snowthrower off crate.
Plastic Fitting Figure 12
Chute Rotator Cable
Figure 13
13