Machine Operation - Nobles Explorer C2 Manual Para El Operador Y De Repuestos

2. Turn the pump on from the control panel. Press the lever
on the wand and spray until there is no air coming out with
the water. This takes approximately 2-3 minutes. Turn the
pump off.

MACHINE OPERATION

Read all instructions before using
this machine.
PRE-SPRAY CARPET
With the use of a pump-up sprayer, pre-spray the carpet with an
approved cleaning detergent. Only use commercially available
mixing and handling instructions on detergent bottle.
combustible material or work in areas were they may be
present.
CARPET CLEANING WITH WAND
1.
2. Verify the vacuum hose and solution hose are securely
connected to the machine and wand.
3. Turn on the pump and vacuum.
Vacuum
Switch
Nobles Explorer C2 (01/2014)
Pump
Switch
Pump
Switch
4. For optimum cleaning results it is suggested to use a V
stroke pattern as shown. Start with an area approximately
4' x 4'. On the back stroke pull the trigger on the wand for
the solution to spray.
5. Let up on the trigger about 4 inches before the end of the
stroke for maximum water recovery.
6. Push the wand forward at a slight angle until next stroke is
slightly overlapping previous stroke.
7.
moving to the next area.
NOTE: Use defoamer any time foaming occurs in the recovery
tank to prevent damage to the motor or other components.
8. Monitor the water level in the solution tank. If solution
tank runs dry, the pump must be reprimed.
9. When the solution tank is low, turn off all the switches,
disconnecting solution hose relieve the water pressure from the
wand by holding the lever on the wand.
EN
English
7 7