Craftsman 850 Serie Manual Del Operador página 16

COOLING SYSTEM
'four engine is air cooled° For proper en-
gine performance and long life keep your
engine clean.
o Clean air screen frequently using a stiff-
bristled brush.
• Keep cylinder fins, levers, and linkage
free of dirt and chaff.
Muffler
Housing
Air Screen
MUFFLER
Do not operate tiller without muffler. Do
not tamper with exhaust system. Dam-
aged mufflers or spark arresters could
create a fire hazard. Inspect periodically
and replace if necessary,, If your engine is
equipped with a spark arrester screen as-
sembly, remove every 50 hours for clean-
ing and inspection° Replace if damaged.
SPARK PLUG
Replace spark plugs at the beginning of
each tilling season or after every 50 hours
of use, whichever comes first. Spark plug
type and gap setting is shown in "PROD-
UCT SPECIFICATIONS" on page 4 of this
manual°
TRANSMISSION
Once a season, lubricate the right hand
gear case grease fitting with 1 oz. of EP
#1 grease.
CLEANING
Do not clean your tiller wllen the engine
and transmission are hot. We do not rec-
ommend using pressurized water (garden
hose, etc.) to clean your unit unless the
gasket area around the transmission and
the engine muffler, air filter and carburetor
are covered to keep water out. Water in
engine wilt shorten the useful life of your
tiller,.
" Clean engine, wheels, finish, etco of all
foreign matter.
. Keep finished surfaces and wheels free
of all gasoline, oil, etc.,
• Protect painted surfaces with auto-
motive type wax.
,_CAUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come into contact with plug_
TILLER
TO ADJUST HANDLE HEIGHT
Select handle height best suited for your
tilling conditions. Handle height will be
different when tiller digs into soil.
1. First loosen handle lock lever.
2. Handle can be positioned at different
settings between "HIGH" and "LOW"
positions.
3. Retighten handle lock lever securely
after adjusting.
/
Handle (Low)
Position
(High) Position
,',2o.. Handle Lock Lever
16