Cebora TD4-HD Manual De Instrucciones página 9

7 - Post gas.
When this function is selected the display H shows the
letter (P).
Using the two keys N and O, it is possible to adjust the
gas flow after welding to between 0 and 10 seconds.
This function is especially useful when welding stainless
steel and aluminum.
P- Setting knob.
When using any synergic program, the
SYNERGIC
knob indicator must be set to the label
5 6
4 7 SYNERGIC.
gram is selected, the display H shows
3 8
the set current.
2 9
This current corresponds to a given
1 10
speed. If you wish to correct this
speed, simply turn the knob clockwise
to increase or counter-clockwise to
decrease.
Changes in wire speed are always indicated on the dis-
play H by a current.
When the program 00 (manual) is in use, adjusts the wire
speed from 0 to 20 meters per minute.
The display H shows the meters per minute.
T - Quick-fitting socket.
This fitting must be connected to the red water
hose leaving the welding torch.
U - Quick-fitting socket.
This fitting must be connected to the blue water
hose leaving the welding torch.
V- 10-pin connector.
This connector must be connected to the
10-pin patch connector of the PULL 2010
torch.
4.2 CONTROLS ON THE WIRE FEEDER REAR PANEL
Q - Gas hose fitting
For extension gas hoses.
R - 14-pin socket connector
For 14-pin plug connector.
When a synergic pro-
Q
R
S
S - Socket
For extension power supply plug.
5 START-UP
Assemble the welding torch on the central adapter (A).
Make sure that the wire diameter corresponds to the one
indicated on the wire feed roller, and load the wire reel. Make
sure that the welding wire passes through the groove in the
roller.
Before connecting the generator power cable, make sure
that the supply voltage corresponds to that of the welding
machine, and that the earth socket functions properly.
Turn on the generator.
Remove the tapered gas nozzle.
Unscrew the contact tip.
Press the torch trigger and release it only when the welding
wire comes out.
Welding wire can cause puncture wounds.
Never aim the torch at parts of the body when loading the
welding wire.
Screw the contact tip back on, making sure that the hole dia-
meter corresponds to the wire used.
Slide the tapered gas welding nozzle back on.
9