Risk Of Electric Shock - INFOSEC UPS SYSTEM E3 LCD RT 800 IEC Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1 . S A F E T Y I N S T R U C T I O N S – S e c u r i t y
IMPORTANT!
Installing and connecting UPSs in a way that does not comply with accepted practices
releases Infosec Communication from any liability.

1.1 Risk of electric shock:

The UPS unit uses potentially hazardous voltages. Do not attempt to disassemble
this equipment as it does not contain accessible components that can be repaired by
users.
All repairs should be performed by qualified technicians only.
The utility power outlet shall be near the equipment and easily accessible. To isolate
the UPS from AC input, turn it off and then remove the plug from the utility power outlet.
The UPS has its own internal power supply (battery). There is a risk that output
sockets may still be live after the UPS has been disconnected from the mains power
supply.
In an emergency situation, switch the UPS to the "Off" position and disconnect the
unit from the AC power supply.
When the UPS is out of order, please refer to section: "trouble shooting" and call
the hot line.
1.2 Connected products:
Combined UPS and connected equipment leakage current should not exceed
3,5 mA.
Make sure that the connected load does not exceed UPS capabilities. To ensure
improved backup time and longer battery life, we recommend a load equivalent to 1/3 of
nominal power.
Do not plug the UPS input into its own output socket.
Do not plug the UPS into a power strip or surge suppressor.
The UPS has been designed for personal computers. It should not be used with
electrical or electronic equipment with inductive loads such as motors or fluorescent
lights.
Do not connect any household appliances such as microwaves, vacuum cleaners,
hair dryers or life-support systems to the UPS.
Due to excessive consumption, laser printers should not be connected to the UPS.
Please replace the fuse only with the same type and amperage in order to avoid fire
hazards.
1.3 Good disposals of the device:
The mains outlet that supplies the UPS shall be located near the UPS and shall be
easily accessible.
Install the UPS in a temperature and humidity-controlled indoor area free of
conductive interference.
It should not be exposed to direct sunlight or sources of heat. Do not cover the
ventilation slots.
Disconnect the UPS from AC power before cleaning with a damp cloth (no cleaning
products).
Do not leave any recipients containing liquid on or near the UPS.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
2
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 01 13 AA 59 209 18
User guide

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

E3 lcd rt 1000 iecE3 lcd rt 1500 iecE3 lcd rt 2000 iecE3 lcd rt 2500 iecE3 lcd rt 3000 iecE3 lcd rt 3500 iec ... Mostrar todo

Tabla de contenido