Risk Of Electric Shock - INFOSEC UPS SYSTEM E2 LCD Serie Manual De Instrucciones

To ensure this product is correctly installed and used appropriately, we highly advise you
to read this user guide very carefully.
1 . I N T R O D U C T I O N
The E2 LCD range consists of high performance pure sine wave UPS units with direct
connection to the PC via a USB port. The UPS is Auto-Regulated to provide balanced
output power and offers complete protection for your servers, gaming PCs, loads with
active Power Factor Conversion power supply, and their critical peripherals like plasma
screens for example in the event of power cuts or fluctuations. If power failure due to
power cuts, power surges, or transient over-voltage occurs, the UPS will very rapidly
transfer your computer equipment to an alternative power supply. This will allow you to
make a backup, close your program(s) and shut the system down correctly. In normal
power supply conditions, E2 LCD will maintain its battery charge in an on-going way to
become completely transparent during all your operations. In other words, this kind of
uninterruptible multifunctional power supply will simplify your tasks. You will be able to
check its operating status quite easily as well as its charge level using the LCD screen.
This high-technology UPS ensures that your equipment has a proper and reliable power
supply. The main features of the E2 LCD range are given below.
2 . M A I N C H A R A C T E R I S T I C S
 On Line Performance technology providing pure sine wave output
 Highly-reliable microprocessor control
 Automatic Boost & Buck output voltage regulator (AVR)
 Built-in USB communication port
 Input voltage regulation and standardization
 Cold start feature if no power supply
 Off-mode charging
 Green Power Function for energy saving (600 and 800 VA models)
 Built-in super smart battery charger
 Automatic restart during AC power recovery
 LCD screen
 Phone & network surge protection (RJ11/45 connectors)
3 . S A F E T Y I N S T R U C T I O N S – S e c u r i t y
 Risk of Electric Shock:

The UPS unit uses potentially hazardous voltages. Do not attempt to disassemble
this equipment as it does not contain accessible components that can be repaired by
users.

All repairs should be performed by qualified technicians only.

The utility power outlet shall be near the equipment and easily accessible. To
isolate the UPS from AC input, remove the plug from the utility power outlet.

The mains outlet that supplies the UPS shall be located near the UPS and shall be
easily accessible.

The UPS has its own internal power supply (battery). There is a risk that output
sockets may still be live after the UPS has been disconnected from the mains power
supply.

Install the UPS in a temperature and humidity-controlled indoor area free of
conductive interference.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
2
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 01 13 AA 59 208 17
User guide