Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT
SPECIFICATIONS
MODEL NUMBER
917,377540
SERIAl.. NUMBER
DATE OF PURCHASE
HORSEPOWER:
6,5
DISPLACEMENT:
tl .5 CU. tN_
GASOLINE
CAPACITY/TYPE:
1 _6 QUARTS
UNLEADED
REGULAR
OIL TYPE (API-SFiSG/SH):
SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW
32°F)
OIL CAPACITY:
20 OZS
SPARK PLUG(GAP:
_030")
CHAMPION
RJ19LM
OR J19LM
V'ALVE CLEARANCE:
INTAKE:
004 - .008
EXHAUST:
.004 - .008
SOLID STATE IGNITION
AIR GAP:
.0125 IN.
BLADE BOLT TORQUE:
35-40 FT. LBS.
The model and serial numbers will be found on a decal attached
to the rear of the
lawn mower housing,Record
both serial number and date of purchase
in space
provided
above.
LAWN
MOWER
Always observe safety rules when performing
any maintenance.
TIRES
° Keep tires free of gasoline, oil, or insect
control chemicals which can harm rubber.
• Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may cause
tire damage.
BLADE CARE
For best results, mower blade must be kept
sharp.
Replace bent or damaged blades,
TO REMOVE BLADE
,, Disconnect spark plug wire from spark plug
and place wire where it cannot come in
contact with spark plug.
,, Turn lawn mower on its side. Make sure air
filter and carburetor are up.
o Use a wood block between blade and
mower housing to prevent blade from
turning when removing blade bolt.
,
Protect your hands with gloves and/or wrap
blade with heavy cloth.
° Remove blade bolt by turning counter-
clockwise. Use a 9/t6" box of open-end
wrench.
• Remove blade and attaching hardware
(bolt, lock washer and hardened washer).
NOTE:
Remove
the blade adapter and
check the key inside hub of blade adapter.
The key must be in good condition
to work
properly.
Replace
adapter if damaged.
70 REPLACE BLADE
° Position the blade adapter on the engine
crankshaft. Be sure key in adapter and
crankshaft keyway are aligned.
, Position blade onthe blade adapter aligning
the two (2) holes in the blade wilh the raised
lugs on the adapter.
• Be sure the trailing edge of blade (opposite
sharp edge) is up toward the engine.
• Install the blade bolt with the lock washer
and hardened washer into blade adapter
and crankshaft.
° Use block of wood between blade and lawn
mower housing and tighten the blade bolt,
turning clockwise.
• The recommended tightening torque is 35-
40 ft. lbs.
IMPORTANT:
Blade bolt is grade 8 heat
treated,
11
Publicidad
Tabla de contenido
