Engine Speed - Sears Craftsman EZ3 Manual De Uso

Theoperation of anylawnmowercan
resultin foreignobjectsthrownintothe
eyes,whichcanresultin severeeye
damage.Alwayswearsafetyglassesor
eyeshieldswhileoperating yourlawn
moweror performing anyadjustments or
repairs Werecommend a widevision
safetymaskoverthe spectacles or
standard safetyglasses.
HOWTO USEYOURLAWN MOWER
CAUTION; Donot runyour lawnmower
withoutmutcherplatein placeanddoor
closedor withoutanapprovedclipping
deflectoror grasscatcher i n place. Never
attemptto operatethe lawnmowerwith
the reardoorremovedor proppedopen.
ENGINE SPEED
The enginespeedwassetat tile factor.i
for optimum performance° S peed
is not
adjustable.
ENGINE ZONE CONTROL
CAUTION: Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury° Do not under any
circumstances attempt to defeat the
function of the operator control The blade
turns when the engine is running,
o Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start and
operate the lawn mower°
TO ADJUST CUTTING HEIGHT
o Raise wheels for low cut and lower wheets
for high cuL
o Adjust cutting height to suit your require.,
ments. Medium position is best for most
lawns.
o To change cutting height, squeeze adjuster
lever toward wheel. Move ,wheel up or
down to suit your requiremer_ts, Be sure ail
wheels are in the same setting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
Plate Tab
Lower Wheels for High Cut
Raise Wheels for Low Cut
TO ATTACH GRASS CATCHER
o
Lever
Close the flip lid Flip lid must be dosed
while operating lawn mower.
Uft the rear door on the mower housing and
place the grass catcher frame onto the
formed tabs on the rear door hinge bracket
The grass catcher is secured to the lawn
mower housing when the rear door Is
Iowered onto the grass catcher frame.
CAUTION: Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear door
removed or propped open.
Hinge
bracket
Formed
tabs
TO EMPTY GRASS CATCHER
,, To remove grass catcher, release operator
presence control bar to stop engine.
. Lift up rear door and remove the grass
catcher by the handle.
° Do not drag the bag when emptying; it will
cause unnecessary wear