Before Starting The Equipment - EINHELL CC-IW 450 Manual De Instrucciones Original

L sound pressure level ........................ 89 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ........................ 100 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Tightening screws and nuts of maximum per-
mitted size
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
Anl_CC_IW_450_SPK9.indb 16 Anl_CC_IW_450_SPK9.indb 16
= 10.04 m/s
2
h
2
- 16 -
GB
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Bit insertion/removal (Fig. 2/Item 1)
Push a drive socket insert onto the square drive
mount (1).
To remove it, pull the drive socket insert off of the
square drive mount (1).
6. Operation
Danger!
To avoid danger, the machine must only be held
using the two handles (2).
6.1 Clockwise/Counter-clockwise selector
switch (Fig. 3/Item 3)
You can select clockwise or counter-clockwise
rotation using the rocker switch (3).
R → loosen screws / nuts (counter-clockwise)
F → tighten screws / nuts (clockwise)
Important!
To avoid gear damage, make sure that the tool
has come to a complete stop before you change
the direction of rotation.
6.2 Working with the impact driver
Loosening:
•
Mount a drive socket insert on the impact dri-
ver (see Paragraph 5).
•
Place the impact driver on the screw/nut and
loosen the screw/nut by pressing the "R" end
of the rocker switch (3).
•
If the screws/nuts are very tight or if they are
rusted, use a tire wrench or torque wrench to
slightly loosen them.
Tightening:
•
Caution! Only use the impact driver for loo-
22.03.2018 13:28:09 22.03.2018 13:28:09