CHARACTERISTICS / INSTALLATION
EN
INTENDED USE
• The QCC-LCS TP interface is intended to be used in nautical applications to control and adjust the brightness of LED
RGBW light sources.
• The product is used to control the RGBW system.
• For fire-prevention reasons, install the QCC-LCS TP interface in a ventilated, controlled-temperature environment,
protected from dust and humidity. Do not expose the dimmer pack to rain or humidity.
• Any other use should be considered improper and unpredictable.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT. IN CASE OF
F
DOUBT, CONTACT YOUR DEALER OR QUICK
THE PACKAGE CONAINS: QCC-LCS TP - conditions of warranty - the manual of installation and use.
TECHNICAL ELEMENTS AND DEFINITIONS
• touch pad: In this specific manual this is a panel in which you just have to tap a key with your finger to activate the
associated function.
• RGBW system: In this specific manual this is an electric lighting system that consists of an assembly of RGBW LED light
sources and electronic devices that control and check such lights..
• DMX512: Communication protocol that transmits the instructions for managing the RGBW system.
• light zone: In this specific manual this is a set of RGBW light sources so connected that they can receive the
instructions to switch on/off and to adjust intensity and colour.
PRODUCT DESCRIPTION
The QCC-LCS TP interface is a control device with a touch pad to control an RGBW system. It can control up to four light
zones.
1. COLOUR PANEL
6. BRIGHTNESS
INSTALLATION
(Refer to the instructions on page 16 of this manual)
• Make the connections following the best practices, using cable of adequate type and size that are appropriate for the
environment conditions.
• Critically inspect your work immediately after installing or servicing the product.
• Turn on the power, MAKE SURE THE POLARITY IS RIGHT.
3. ON/OFF
4. STORE
5. SCENARIO
7. RGBW KEYS
CUSTOMER SERVICE.
®
8
QCC-LCS TP - REV003A
2. ZONE CONTROL
8. WHITE COLOUR CONTROL
QUICK SPA