Sears Kenmore 110.2022 410 Serie Manual De Uso página 13

TROUBLESHOOTING
First try the solutions suggested here
for assistance and to possibly avoid a service call.
Washer won't run or fill,
washer stops working
or wash light remains
on (indicating that the
washer was unable to fill
appropriately)
Check for proper water supply. Both hoses must be attached and have water flowing to inlet
valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Washer won't run or fill,
washer stops working
or wash light remains
on (indicating that the
washer was unable to fill
appropriately) (cont.)
Washer not draining/
spinning, loads are
still wet or spin light
remains on (indicating
that the washer was
unable to pump out
water within 10 minutes)
Check proper electrical supply.
Normal washer operation.
Washer may be tightly packed.
Small items may have been caught
in pump or between basket and tub,
which can slow draining.
Use a cycle with a low spin speed.
The washer may be tightly packed or
unbalanced.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not interrupt
cycle.
Remove severalitems,rearrange load evenly in basket.Close lid
and press START/PAUSE/Unlock Lid.
Do not add more than I or 2 additional items aftercycle has
startedto avoid tightlypacking or unbalancing.
Do not add more water to the washer.
Empty pockets and use garment bags for small items.
Cycles with lower spin speeds remove Jess water than cycles
with high spin speeds. Use the recommended cycle/speed spin
for your garment. To remove extra water in the Ioad_ select
Drain/Spin. Load may need to be rearranged to allow even
distribution of the load in the basket.
Tightly packed or unbalanced loads may not allow the washer
to spin correctiy_ leaving the load wetter than normal, Evenly
arrange the wet load for balanced spinning. Select the Drain/
Spin cycle to remove excess water. See "Using Your Washer" for
loading recommendations.
13