Adjusting The Helmet - Dynafit HELMETS ST Instrucciones De Uso

GENERAL: Please read these instructions thoroughly before
A
using this product and follow all the information contained with-
in. Failure to observe these instructions can lead to a reduction
in the protection this product provides.
Studied as a protection for the head, this helmet is intended for
skiers and snowboarders , and it is also conceived as a climbing
helmet. Please familiarise yoursef with this product before use.
Please note the following information: skiing and snowboarding,
as well as mountaineering and climbing are dangerous sports
that can involve unforeseeable risks. You are responsible for any
activities that you undertake and any decisions that you make.
Please find out about the risks involved in these type of sports
prior to practising them. DYNAFIT recommends full training by
appropriate personnel (e.g. mountain guides, climbing trainers)
before undertaking any mountaineering or climbing activities. In
addition, anyone practising these sports is fully responsible for
finding out about the proper course of action and techniques
required for the safe performance of any rescue operations. The
manufacturer is not held liable in any form for the consequences
of abuse or incorrect use of equipment. Please also take note of
the certification details relevant to any other protective equip-
ment components used.
Manual_ST_helmet.indd 11
INSTRUCTIONS FOR USE:
B

ADJUSTING THE HELMET:

Warning: A helmet can only provide optimum protection if it is
properly and correctly fitted to match your individual head size
and shape. If this is not the case, DO NOT USE THE HELMET.
Swap it for another size or another model. A helmet that does
not properly fit your head, or which is too loose, will significantly
impair the helmet's protective capability.
Illustration 1 - Adjusting helmet fit to your head size: First, ex-
pand the headband to its maximum dimensions via the adjust-
ment wheel (turn anti-clockwise) and put the helmet on. Then
turn the wheel clockwise until the headband sits snug to your
head. To get the perfect fit, you can slide the headband vertically
up or down at the back.
Illustration 2 – Adjusting the chin strap: The chin strap should
sit at the sides of your head and is fastened with the buckle
under your chin. For a snug and comfortable fit, the strap length
can be adjusted under your chin. To position the strap properly
at the sides of your head, shift the divider and adjust the strap
length to fit your head shape so that the strap sits below your
ears on both sides. The straps must not cover your ears. When
the buckle is closed, the chin strap should not apply any pres-
sure on your Adam's apple.
Illustration 3 - Attaching a headlamp: bring the clips to fix the
headtorch in the provided places on the helmet, slide the head-
11
14.02.17 11:40