Opus MB 300 Manual De Usuario página 5

• It is necessary to check and supervise if the equipment being operated correctly
In case of any malfunctions before contacting, the service department or dealer.
• Equipment must not be located outside
• Equipment must be operated in accordance with the general Health & Safety rules.
• Repairs must be carried out by authorized sta during the guarantee period
PREPARATION TO WORK
4
• Unpack the equipment and fit the extended back support on the top of the main back
support plate in the pre-drilled holes with the screws and Allen key supplied.
• Fit the binding handle to the equipment with the screw and Allen key supplied, tighten
firmly.
• In the slots in back (10) of the equipment are two binding bars and the de-binding wedge.
• Tool for selecting the channel size has a magnet so you can keep it on the equipment hous-
ing.
• The binding guide bars A & B fit at the back of the binding slot by magnetics and has a
scale on each.
The third guide bar fits over the binding jaw. These three bars form the COVERGUIDE SYSTEM
and were specially designed to make it quick and easy to put covers and pagers into the
Metalbind channel for binding. A clear view this is shown in point 2 "DESCRIPTION".
PRESSURE INDICATOR LED DISPLAY UNIT
5
The pressure indicator gives you the facility to save the best pressure for the channel when
binding large numbers of the same presentations/documents giving you a perfect result and
speeding up the job. The LED,s will move up the scale from 1 to 10 when the right binding
pressure you set is reached, you can hear a single sound then release the binding handle.
1. Press START/SET button on the LED display, it will show the last value set.
If this value is good for the next job, you can start binding right away.
2. To set a new binding pressure, press the START/SET button and hold it on until the LED light reaches
the number you wish to set then release the button and the level is set.
3. During binding process, as you increase the pressure with the handle the LED, s move up the scale
until it reaches the level set and makes a single sound release the handle.
4. When you stop binding for over a minute, the unit goes into an energy-saving mode and LED flash,
when it is in this mode you can still bind and it will sound when you reach the correct pressure.
5. When the binding equipment is not used for 5 minutes, the pressure unit will turn its self o to save
the battery, to start again just press the START/SET button once and continue binding.
CHANGING THE BATTERY
The unit is powered by the CR2032 lithium battery, which is on the right side
on the back of the equipment. When the battery is, low the sign at the top
of the scale comes on warning you to change the on the battery the lower
the battery get the faster the light flashes.
See diagram opposite
1. To remove the battery* slide it out by using a small thin screwdriver.
2. Slide the new battery in with the plus sign + to the right away from equipment.
* Batteries when empty must be collected separately and cannot be put together with normal type of wastes. Information concerning
collection points for empty batteries are available at your local city or municipal authorities o ces or on the internet.