Opus MB 300 Manual De Usuario página 7

DE-BINDING
7
Note!
When de-binding 28 mm and 32 mm, channels it is easier to remove
the extended back support.
8. Make the changes to the document/presentation and rebind.
9. Cover can be re-used two or three times.
DE-BINDING
back cover
1. Place the de-bind wedge in the book 4 or 5 pages
from the back cover, flat side towards the front of the book
and sharp edge towards the spine.
2. To de-bind documents thicker than 16 mm.
• Place the documents on the equipment front down
• Open the book and put the wedge in level
with the de-binding hooks
3. Fit the ends of the wedge in the de-binding hooks.
4. Close the clamping lever until the channel is flat
against the binding plate and you feel a resistance.
5. Holding the clamping lever with one hand and moving
the binding handle forward 4 or 5 times until covers are loose.
6. Move the binding handle to the open position.
7. Move the clamping lever fully to the left.
Remove covers and pages together with the wedge.
Open and remove the wedge carefully from the documents.