Tabla de contenido
Publicidad
A
B
3
2
10
6F22
1
2,3
BACKUP FUNCTION
If the AC power supply is interrupted, the clock display goes
off and the alarm setting is canceled. To back up the clock and
alarm, insert a 6F22 battery in the battery compartment on the
rear of the unit. → A
• The backup battery is not for radio reception.
Note
The backup function lasts about 10 minutes. Set the clock
again if 10 minutes have passed after a power interruption.
Replacing the battery
Replace the battery with a new one if the clock display flashes
or the alarm timer does not work properly when you connect
the AC power cord again.
Note on battery
• When you are not going to use the unit for a long period of time,
remove the battery to prevent possible electrolyte leakage.
• To prevent the risk of electrolyte leakage or explosions,
never recharge the battery, apply heat to it, or take it apart.
SETTING THE CLOCK → B
1 Connect the AC power cord to a wall outlet (a).
The clock display begins flashing. If the clock is not
displayed correctly, disconnect the AC cord and remove the
backup battery if inserted. Then, connect the AC cord and
insert the backup battery again.
2 While holding down aSET, press gHOUR to set the hour.
Holding down both buttons changes the hour faster.
7:00
7:00 a.m.
• 7:00
7:00 p.m.
3 While holding down aSET, press hMIN to set the
minute.
Holding down both buttons changes the minutes faster.
English
Publicidad
Tabla de contenido
