Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
or disassembling it and before cleaning or
servicing the unit.
•
Engine driven appliances: beware of sharp
and/or moving parts. Always keep your hands
away from the moving parts when using,
cleaning or servicing the appliance.
•
Heating devices: wait until the appliance has
cooled down before you touch the housing and
parts of the unit.
Be extra careful during cleaning and servicing.
INTRODUCTION
This stylish blender has stainless-steel cutting
blades and a powerful motor, so you can chop fruit
and vegetables, and purée shakes and juices with
ease. Using the hole in the lid, you can also add extra
ingredients during blending without spillage. The
rubber feet stop the blender moving while in use.
OPERATION
The blender includes the following parts:
•
On/off/speed switch enabling you to
opt for one of the two continuous
blending settings or the pulse setting.
•
Carafe with measure.
•
Lid with hole for extra ingredients.
BEFORE USE
•
Clean the appliance and its parts (see
'Maintenance and Cleaning').
•
Fit the carafe onto the base.
•
Put the lid on the carafe.
•
Position the filling cap on the lid and fix it into
place by turning it 90 degrees.
To dismantle the appliance repeat the steps above
in reverse order.
BLENDING
•
Cut the fruit and/or vegetables into pieces that
will fit easily into the carafe.
•
Put the pieces into the carafe and put the lid
on the carafe to avoid spattering.
•
Plug in the blender.
•
Set the blender to the required setting. It
takes a few seconds to blend the ingredients.
The longer you keep the blender running, the
finer the ingredients will be blended. Do not
keep the blender running for more than 2
minutes continuously (see 'Additional safety
instructions').
•
If you want to add extra ingredients, simply
turn the filling cap 90 degrees and remove it
from the lid. If the pieces are too large for the
hole, turn off the appliance, remove the lid and
put the pieces into the carafe. Put the lid back
on the blender before turning it on again.
•
Once you have finished blending, turn off the
appliance by turning the switch to "0", then
unplug the blender from the wall.
•
Note: a blender mixes and purees. The 'blade'
is purposefully blunt so that it pulverises
ingredients. A blender does not cut and cannot
take the place of a food processor or mincer.
MAINTENANCE AND CLEANING
•
Take care not to injure yourself on the sharp
cutting blades at the bottom of the carafe.
•
Ensure that the appliance is not plugged in.
•
The blender cutting blade unit can be removed
for cleaning by loosening the threaded ring
under the carafe. Turn the carafe upside down,
then turn the ring anti-clockwise to loosen the
cutting blade. (Turn it clockwise to tighten it.)
•
After every use, clean the inside of the carafe
and its parts using a damp cloth and a little
detergent. Carefully remove all pulp remains
from the blender, taking care to remove pulp
from around the rotating blades too.
•
The carafe and removable parts can be
cleaned with soapy water. However, do not use
soapy water to clean the base.
•
Clean the exterior of the base with a soft,
damp cloth.
•
After cleaning, reassemble the appliance for
storage.
ADDITIONAL SAFETY INSTRUCTIONS
•
Note: a blender is only suitable for processing
fluids and foodstuffs that contain a high
degree of fluid, such as vegetables, fruit, ice
cubes and sauces. A blender should never be
used for exclusively dry items, such as nuts or
chocolate, as the appliance may overheat.
This blender's mixing and pouring carafe is
•
made from real glass, a high-quality, very
hygienic natural material that radiates
quality. Glass is of course fragile, so to
prevent damage, be careful not to drop or
strike the glass carafe. Regularly check the
carafe for damage, even under the threaded
ring. Regularly remove the ring to properly
clean the blades and check the carafe. Do not
use the blender if the carafe is damaged!
•
Switch off the blender and remove the plug
8
Publicidad
Tabla de contenido
