Reassembling Receiver Halves - Tippmann TMC Serie Manual Del Usuario

E
N
5. Insert the
Bumper
G
will not return. Place the Rear Bolt / Spring / Guide Pin assembly inside the right receiver
L
half. Inspect the Rear Bolt
I
S
H

Reassembling Receiver Halves

*
( indicates lubricate this part with a small amount of Tippmann Certifi ed Marker Oil)
1. Refer to the graphics, and place the following parts into the right Receiver half:
Trigger Pins (51), black colored Sear Pin (54),
Sear (52), and gold colored Sear Spring (53).
2. Set the Trigger (49) onto the Receiver Pin 51)
as shown. Install the silver colored Trigger
Spring (50).
3. Install the Trigger Adapter Assembly (55) onto
the remaining Receiver Pins (51).
4. Slide the Front Bolt
(22).
5. Install the Linkage Arm
the Front Bolt and the Rear Bolt
The longer end of the Linkage Arm
goes towards the Front Bolt. Be sure
that the tab on the Linkage Arm fi ts into the slot of the Charging Handle (arrow above).
When properly assembled, they fi t together as shown in the circle below. Ensure the
Charging Handle Spring is seated as
shown by the top arrow at right.
6. Ensure that the Gas Line (34) is
routed as shown, and fi ts into the
receiver half. Connect the Trigger
Adapter to the Trigger with the
Trigger Link Arm (48) over the Gas
Line.
16
(8) and
Spring Guide Pin
(95). Ensure spring and guide pin are installed correctly. If it not, the Rear Bolt
O-Ring
10
*
(23) onto the Power Tube
*
(47) between
(7) into the
Rear Bolt
(10) for damage and replace if necessary.
9
8
7
50
*
(9).
S
PRING PROPERLY SEATED
TP04405 | TMC 68 Caliber Owner's Manual | Rev. 04/18
(9). Next install the Rear Bolt
95
51
55
48
49
53
52
54