Converting From Hopper Fed To Magazine Fed; Loading The Mag Fed Magazine - Tippmann TMC Serie Manual Del Usuario

7. Align the Magazine
Release components
in the right receiver
half. Put the Safety
Selector Switch (in
Fire mode) through
the left Receiver Half.
Align with the openings
for Mag Release and
Safety Selector Switch
in the right Receiver
Half. Carefully install
the left receiver half
(make sure halves fi t
fl ush).
8. Insert seven of the
eight Receiver Screws.
Leave the one identifi ed #41A (page 14) out for now.
9. Reinstall the Handguard and secure with the remaining Receiver Screw (41A) from step 7.
10. Apply a small amount of marker oil onto the barrel O-Ring, and carefully screw the
Barrel (27) into the receiver.
11. Slide the Magazine up into the marker until the tabs lock it in place.
12. Slide the Feed Tube onto the Receiver and fasten it in place using the Thumbscrew (65).

Converting from Hopper Fed to Magazine Fed

1. Replace the Feed Tube with the Mag Fed Cover Plate (76). This Cover Plate contains
the Ball Latch (75). The Ball Latch can be removed for
replacement. The Mag Fed Ball Latch is different from the
Loader Fed Ball Latch. They are not interchangeable. The Ball
Latch Retaining Plate (74) holds the Ball Latch in place.
2. The Cover Plate does not hinge like the Feed Tube does.
It has a stub that has the same angle as the Feed Tube, so
insert it at the same angle as the opening for the Feed Tube in
the right Receiver. The Cover Plate is retained by same Thumb Screw (65).
3. Replace the fake Magazine with the real Magazine. When inserting either magazine,
you will feel a positive latching of the Magazine into the magazine well.
4. The Magazine is released by the Magazine Release Button for reloading. The release is
spring-assisted so it quickly ejects the Magazine from the magazine well.

Loading the Mag Fed Magazine

Loading instructions are molded into the side of the magazine.
1. It is important to wind up the spring by rotating the
knob on the magazine in the clockwise direction.
2. Paintballs may be inserted past the magazine ball
catch, but if paintballs are fragile, we recommend
retracting the ball catch release (arrow).
3. The Magazine holds 20 paintballs, but loading 19
is best. If magazines are to be carried in a battle
pack, this ensures the 19 balls are not under any
compression, compression may cause fl at spots on
the paintballs.
TP04405 | TMC 68 Caliber Owner's Manual | Rev. 04/18
25
47
23
70
50
9
22
52
49
34
E
N
G
L
S
H
53
32
17
I