Operational Errors; Maintenance And Care; Fuse Replacement; Care - 3M CapMix ESPE AG Instrucciones De Servicio

SEITE 4 - 148 x 210 mm - 063/0/-/51+ F -
9. Operating Errors
Error Possible
cause
Time display is off, Power failure
even though the
unit is switched on
Motor fails to run Cover of the
when the unit is unit is open
switched on
Motor is
overheated
NOTE: The CapMix device should be repaired by
3M ESPE or an 3M ESPE-authorized repair facility only.

10. Maintenance and Care

The device requires no maintenance.

10.1 Fuse Replacement

Shut the unit off and disconnect the power cable.
The fuses are located on the back of the unit next to the
power switch.
With a screw driver press down on the small bracket of
the fuse unit, squeezing the unit out a small distance.
Fuse unit
Remove the fuse unit from the device.
Press the catch lightly in an upward direction so that
the fuse holder can be pulled out. Remove the fuse
from the fuse holder and replace with a new fuse.
4
SCHWARZ - 03-0755 (sr)
Remedy
Check both the
power cable and
main voltage
Close protective
cover
Allow the unit
to cool
Catch
Fuse holder
Attention: Use only fuses with identical ratings.
Insert the fuse holder in the fuse unit until the catch
audibly locks in place, then replace the fuse unit in
the device. Make sure that the bracket of the fuse unit
points towards the power switch of the device.

10.2 Care

Clean all components with a soft cloth and, if necessary,
a mild detergent.
For disinfection use commonly available disinfection
sprays. Under no circumstances use solvents or scouring
agents as they will permanently damage the plastic.
Do not allow detergent or water to enter the mixing unit.
The following agents can be used for disinfection:
Pursept-A (Merz) and FD 322 (Dürr).
Pursept-A and FD 322 are not available in all countries.

Customer Information

No person is authorized to provide any information that
deviates from the information provided in this instruction
sheet.

Warranty

3M ESPE warrants this product will be free from defects
in material and manufacture. 3M ESPE MAKES NO
OTHER WARRANTIES INCLUDING ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE. User is responsible for
determining the suitability of the product for user's
application. If this product is defective within the
warranty period, your exclusive remedy and 3M ESPE's
sole obligation shall be repair or replacement of the
3M ESPE product.

Limitation of Liability

Except where prohibited by law, 3M ESPE will not be
liable for any loss or damage arising from this product,
whether direct, indirect, special, incidental or conse-
quential, regardless of the theory asserted, including
warranty, contract, negligence or strict liability.
Information valid as of 10/03