Beurer BARBERS CORNER HR 5000 Instrucciones De Uso página 25

To activate the travel lock, press and hold the ON/OFF switch
indicator begins to flash. The device is now locked. If the ON/OFF switch
when the device is locked, the travel lock symbol will light up in the display to indicate that the
device is locked.
To deactivate the travel lock, press and hold the ON/OFF switch
Direct drive function
If the battery is completely flat, you can continue using the device immediately via mains operation.
Tips before cutting hair
• Make sure that you wash and dry the hair to be cut.
• Comb the hair to be cut thoroughly in order to remove any knots and to smooth down the hair.
• Wear a hairdressing cape to stop hair from landing on your neck.
Cutting hair using a comb attachment
• Select one of the two comb attachments and attach it to the device as shown. Make sure that
you hear and feel the comb attachment click into place. We recommend that you start with
the comb attachment with the longest cutting length initially so you can then slowly work your
way up to your desired length.
• In order to adjust the cutting length on the comb attachment, slide the
sliding switch on the rear of the comb attachment to the desired cutting
length as shown.
• Press the ON/OFF
play begins to light up.
• Guide the device slowly through the hair. Ensure that the comb attachment sits as flat on the
head as possible.
• Always only trim small areas.
• Cut the hair against the direction of growth. If the hair grows in different directions, use the de-
vice in multiple directions.
• Press the ON/OFF switch
turns off.
switch to switch on the device. The operation dis-
again to switch off the device after use. The operating display
25
for 3 seconds. The travel lock
is briefly pressed
for 3 seconds.