Replacing The Coupling Ball - V.ORLANDI GS900 Instrucciones De Montaje

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS

5.3 REPLACING THE COUPLING BALL

Uncouple the trailer from the tractor unit (follow steps 1, 2, 3, 4, 5, in the
1)
UNCOUPLING section 3.2 at page 14/24 herein);
Remove all the coupling ball screws (8) recover and dispose of the
2)
coupling ball (5) accordingly (please also consult the DISPOSAL section
7 at page 23/24 herein);
Assemble on the new coupling ball (5) and lock on with eight M16
3)
class 10.9 screws at a 100 Nm torque wrench setting (apply some
thread-locker product);
4)
Complete procedure by tightening the screws at a 250-300 Nm torque
wrench setting according to the screw number sequence as illustrated
below.
CAUTION! Do not re-assemble any one of the screws that turn
N
out to be damaged during any one of these operations back
O
T
on. They must strictly be replaced (please also consult the
E
DISPOSAL section 7 at page 23/24 accordingly);
8
GS900 DRAWBAR COUPLING
5) Couple the trailer back on as
5
described in the COUPLING UP
section 3.1 at page 12/24 herein.
21/24
CHAP. 5
REV. C
3
5
8
2
1
7
6
4
PAG.