Time Zone Setting - TFA Dostmann WEATHER BOY Instrucciones De Uso

TFA_No. 35.1159_Anleitung_ 17.06.2020
WEATHER BOY – Wireless weather station
• Once the DCF time reception is deactivated the clock and date must be manually set.
• Confirm the setting with the SET button.
• Press the SET button again and the setting sequence is shown as follows: the 12 or 24 hours system (24hr - default), time
zone (Hr 00 - default), hours, minutes, day/month sequence (European version - default) or month/day sequence (Ameri-
can version), year, month and day, the language of the day-of-the-week (GE - default), the temperature unit °C or °F (°C -
default), the city code (BER - default) and the weather symbol. Adjust the settings with the +/CH or –
• Confirm the settings with the SET button.
• If the DCF reception is activated (RC ON), the manually set time will be overwritten by the DCF time when the signal is
received successfully.
7.1.1 12 or 24 hour system
• In setting mode you can choose between the 12 - or 24 hours system. In the 12 Hr system AM or PM (after 12 o'clock)
appears on the display.

7.1.2 Time zone setting

• In the setting mode you can make the time zone correction +12/-12).
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is different from
the DCF time (e.g. +1=one hour plus).
7.1.3 Day-of-the week language
• You can set the day-of-the week language in setting mode: German (GE - default), French (FR), Spanish (ES), Italian (IT),
Dutch (NE), Danish (DA) and English (EN).
28
18:09 Uhr Seite 15
/WAVE button.
WEATHER BOY – Wireless weather station
7.1.4 City selection
• It can be chosen from among 164 cities. See the city list at the end of this manual. The city code will start flashing. Set the
first letter of your location with the +/CH or – /WAVE button. Confirm with the SET button. Set the second and third letter
in the same way. Display ERR - Repeat procedure.
7.1.5 Weather symbol setting
• For a correct weather forecast the actual weather conditions have to be set. The weather station will start the first forecast
8 hours after the setting of the current weather status. The weather forecast may be not accurate if the entered weather
symbol is incorrect.
7.2 Display mode
• Each press on the SET button in normal mode will change the display between date, alarm time and seconds.
7.3 Alarm function
• Choose with the SET button the alarm time AL.
• Press and hold the SET button.
• AL and 6:30 (default) or the last adjusted alarm time appear on the display.
• The hour digits flash.
• Press the +/CH or – /WAVE button to set the hours.
• Confirm the setting with the SET button and set minutes in the same way.
• Press the SET button again and the snooze symbol flashes. Press the +/CH or –
to 30) for the snooze function or to switch it off (OFF). The default setting is 8 minutes.
• Confirm the setting with the SET button.
/WAVE button to adjust the minutes (1
29