Bosch ROTAK 320 Instrucciones De Servicio página 13

F016 L70 451.book Seite 2 Mittwoch, 31. Januar 2007 9:38 09
Product Specification
Lawnmower
Part number
Rated power [W]
Blade width [cm]
Height of cut [mm] 20 – 60
Grassbox capacity [l]
Weight [kg]
Protection class
See rating details on
Serial Number machine
Intended Use
This product is intended for domestic lawn mowing.
Intended Use is related to operation within 0 °C and
40 °C ambient temperature.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your machine. It is important
that you read these instructions carefully.
When fully assembled the machine weighs approxi-
mately 7 kg. If necessary, obtain assistance to re-
move from packaging.
Take care when carrying the mower to the lawn, as
the blades are sharp.
Delivered Items
Carefully remove the machine from its packaging
and check that you have all the following items:
– Lawnmower with handle assembly
– 2 Handle bottoms
– 2 Bolts
– 2 Wing nuts
– 2 Screws
– 2 Grassbox halves
– 2 Cable clips
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
13 • F016 L70 451 • 07.01
ROTAK 320
3 600 H85 ..
1000
32
28
7.0
/ II
English - 2
Operating Controls
1 Switch lever
2 Safety button
3 Handle top
4 Mains plug**
5 Cable restraint**
6 Grassbox
7 Deflector guard
8 Handle bottom
9 Serial Number
10 Wheels
11 Ventilation slots
12 Height of cut indicator
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
For Your Safety
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The blades continue to rotate for a few sec-
onds after the machine is switched off.
Caution – do not touch rotating blades.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use approved extension
cables.
Extension cords/leads should only be used if they
comply with H05VV-F types or H05RN-F.
If you want to use an extension cable when operat-
ing your product, only the following cable dimen-
sions should be used:
2
– 1.0 mm : max length 40 m
2
– 1.5 mm : max length 60 m
2
– 2.5 mm : max length 100 m
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
If the supply cord is damaged, it must be replaced by
a Bosch Service Centre.