Installation Instructions: Electrical System For Towing Hitch - Westfalia 315 097 391 101 34/04 Instrucciones De Montaje

Peugeot 807, citroen c8, fiat ulysse, lancia phedra
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
Installation instructions:
Electrical system for towing hitch
Installation instructions:
Electrical system for towing hitch
Important notes
Read the installation manual prior to starting work.
The electrical kit should only be installed by qualified personnel.
Caution – Disconnect the battery!
Danger of damage to the vehicle's electronic system. Data which are stored electronically may
get lost.
Read out the fault storage prior to starting work.
Make sure prior to drilling that no objects such as cables, for example, are located behind the covers.
Deburr any bare body parts, like bore holes, and seal them with the help of some rust inhibitor.
Note
During installation special attention has to be paid to the following points:
Cables must not be pinched or damaged.
All sealing elements have to be installed properly.
The socket gasket has to be positioned on the insulating sleeve and not on the individual wires.
Lay the cables such that they do not rub on the vehicle and are not bent.
Do not lay any cables near the exhaust system.
Install the controller such that it is protected against the ingress of humidity. The cable connection
should always face downward.
Degrease the trailer control module to ensure better adhesion on the adhesion points.
When a trailer is used, the rear fog lamp of the traction vehicle is deactivated.
In the case of trailers without rear fog lamp, a rear fog lamp has to be retrofitted.
When a trailer is used, the parking distance control of the traction vehicle is deactivated.
When a direction indicator lamp fails, also on the trailer, this is indicated by a higher flashing frequency. No
additional direction indicator check is necessary.
A socket adapter may only be used in conjunction with a trailer. When the trailer is no longer used, remove
the socket adapter.
Correct trailer operation has to be checked using a trailer or a test instrument with load resistors.
Subject to technical alterations!
Peugeot 807, Citroen C8,
Fiat Ulysse, Lancia Phedra
Hersteller: Westfalia Automotive GmbH & Co. KG
315 097 391 101 34/04
13

Publicidad

Tabla de contenido
loading

Tabla de contenido