Installation And Start-Up - Oase Lunagard 20 Instrucciones De Uso

Installation and operation
-
-
-
-
-
The area of illumination of the Lunagard light
The area of illumination of the garden light can be adjusted as desired by turning
the roller. The Lunagard is supplied with the area of illumination set to the "front".
To change the area of illumination from the "front" to the "back", the following steps
are necessary:
1. Remove front screen (2) by pressing in the two pressure clips at the side (13)
13 2 2. Put roller (14) in the rear area of illumination with the screw ring (1)
3. Hook the two hooks (15) of the front screen (2) into the two slots (16) of the
4. Screw in front screen (2). Both pressure clips (13) must click into place.
Caution:
Make sure that the roller (14) and the connecting lead are (18) correctly positioned.
The screw ring (1) must lie completely in the "front" or "back" adjustable range! The
screw ring must not be jammed by the housing or the front screen (see diagram)!

Installation and start-up

The Lunagard garden light can either be installed at ground level with the stake or
fixed to walls and posts.
Installing the Lunagard with the stake
1. Insert the end of the stake (3) with the radial groove into the socket on the
2. Push the stake (3) into the narrow part of the socket. The stake must click into
3. The connecting lead (18) can either be fed through the cable opening at the
4. Feed the connecting lead (18) through the strain release (21) and the relevant
5. Place the garden lamp in your chosen location in the garden.
Lunagard NEU.p65
GB Operating instructions
Always disconnect the plug of the garden light before you carry out any work
on the garden light!
If using in pond: Disconnect the plug of the garden light and the plugs of all
devices that are in the pond before you carry out any work on the garden light.
When installing the garden pond, observe a safe minimum distance of 0.5 m
between the light and any flammable illuminated object.
The garden light must not be covered.
Ensure that the distance between the garden light and the transformer is such
that the transformer cannot be affected by the heat given off by the garden
lamp.
The distance between the transformer and the edge of the pond must be at
least 2 m. Position the transformer so that it is safe from flooding!
and unscrewing it.
housing (17).
underside of the housing (17).
place!
front or the back. To do this, pull out the cable screen at the front (19) or the
back (20). Please retain the cable screen in case you need it later on.
cable opening on the underside of the housing (17).
13
GB
24.10.2002, 12:44
13