Snooze Function - Silvercrest KH 2199 Instrucciones De Uso

Snooze Function

Pressing the SNOOZE
For as long as the snooze function is activated the indicator "Zz" blinks in the
display. After these 8 minutes, the alarm tone is repeated. Place the switch
ALARM ON/OFF/AUTO
pletely.
Wakening with the alarm tone
When the clock is set correctly, as described above:
1. Place the sound volume controller OFF/BUZZ/VOLUME
"OFF/BUZZ". A "Click" will be heard.
2. To activate a wake-up call with the alarm tone place the ALARM ON/
e
OFF/AUTO
"Zz" appear in the display
The alarm tone sounds at the set time and then switches itself off after about
one minute. The radio alarm sounds again on the next day at the set alarm
time. Place the switch ALARM ON/OFF/AUTO
alarm completely.
Projection
Attention! When used properly, the radiation from the projection of the
display is not at all dangerous!. However, avoid looking directly into the
light beam and do not aim the beam at other persons or at animals.
To display the time correctly on a wall or the ceiling, the hinged projection
element needs to be swivelled into the correct position and the room must
be appropriately darkened..
1. Place the PROJECTION ON/OFF
2. Adjust the projection element as desired. The time is projected onto the
required position. The projection distance is approx. 40cm - 3m.
3. Adjust the clarity of the projection with the projection focus
r
button interrupts the alarm tone for approx. 8 minutes.
e
at "OFF" to switch the alarm function off com-
at "AUTO". The symbol for the alarm function
i
.
e
at "OFF" to disable the
u
switch at ON.
- 67 -
o
at
and
l
.