Use; Switching On The Machine; Switching Off The Machine; Restarting After Overloading - Unitec SKF 025 Instrucciones De Manejo

Use

Use

Switching on the machine

Switching off the machine

Restarting after overloading

40
1
2
3
4
Move the main switch (1) to position "1".
‹
Push the green pressure switch (2) to switch on the milling
‹
motor. The yellow indicator light (4) lights up.
Push the red pressure switch (3) to switch off the milling
‹
motor.
Move the main switch (1) to position "0".
‹
NOTE
► The red indicator light (5) flashes in the event of temporary
overloading.
► In the event of continuous overloading, the red indicator light
(5) lights up and the milling motor is switched off.
In order to switch on the machine again after overloading,
‹
press the red pressure switch (3) first followed by the green
pressure switch (2).
5
SKF 25