Cleaning; After Every Use - Unitec SKF 025 Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning

Replacing the reversing plate
Cleaning

After every use

CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
42
When the reversing plate is completely worn, it must be replaced
by a new one:
Remove the fixing screw and remove the reversing plate.
Insert the reversing plate and tighten the fastening screws
again.
WARNING
Switch off the machine and pull the plug out of the mains
socket before starting maintenance and cleaning.
Due to the risk of injury to persons or damage to the ma-
chine, cleaning with compressed air is prohibited.
CAUTION
Never immerse the machine in water or other liquids.
Remove swarf on the machine.
Clean the tool on the underneath of the machine.
Clean the guide rollers.
Put the machine and accessories into the transport case.
SKF 25

Publicidad

Tabla de contenido
loading

Tabla de contenido