Velleman CAMSET15 Manual Del Usuario página 5

Videoportero b/n
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Powering through the Monitor
1. Electronic lock (12V-1A) (not
incl.)
2. AC/DC power supply
5. Installation
• Keep the door phone system at least 1m away from a TV set or radio.
• Note that the system may be affected by radio frequency interference in areas near broadcasting station aerials.
• Keep all DC wiring at least 30cm away from 100 ~ 240VAC wiring, fluorescent lighting or dimmer switches.
Otherwise, cross the AC wiring in a 90° angle.
• The system may be affected by a strong electromagnetic interference present in the AC line.
• Install and fix the devices securely.
a. Installing the Camera Station in a Door
• Make a hole in the door referring to the measurements from figure 5. All measurements are in mm.
• Punch a hole in the bracket and fasten the bracket onto the backside of the door. Pass the wire through the
hole.
• Connect the wire to the camera station (see "Wiring").
• Fasten the camera station to the bracket using the included cap head hex screws. Start by fastening the
bottom of the camera station. Slide the middle upper part up, fix the upper part and close the middle upper part.
Fig. 5
b. Installing the Camera Station into the Wall
• Make a hole in the wall referring to the measurements from figure 6. All measurements are in mm.
• Punch a hole in the bracket and fasten the bracket into the wall. Pass the wire through the hole.
• Connect the wire to the camera station (see "Wiring").
• Fasten the camera station to the bracket using the included cap head hex screws. Start by fastening the
bottom of the camera station. Slide the middle upper part up, fix the upper part and close the middle upper part.
CAMSET15
Fig. 4
5
VELLEMAN

Publicidad

Tabla de contenido
loading

Tabla de contenido